Check the listing for details. Corner and Pole Mount Arm For Unifi Bullet Cameras (G3, G4, G5, Pro, AI). Condition: New. Listed at 16.99 USD. This is a camera mount that is compatible with the Unifi series of bullet cameras, including the G3, G4, G5 (Bullet and Pro), and AI.The mounting arm is designed to attach to corners of buildings, square posts, gutter downspouts, and poles of almost any size.The mount offsets the camera from the mounting surface which may be needed to clear obstructions and achieve a better viewing angle. There is a passage from the back of the mount large enough for an ethernet connector (including the rubber boot) and there are various methods for routing the cable, some of which require you to drill a hole to open up the weather-sealed passages. The mounting arm can either be screwed to your mounting surface, or strapped with heavy duty zip ties or steel hose clamps. Stainless steel screws and zip ties (white for white, black for other colors) are included. Steel hose clamps are not included but can be found in various sizes at almost any hardware store. These mounts are heavy duty - the plastic is several millimeters thick throughout. It is very sturdy and we have not tried to skimp on materials. We believe our mount design is much thicker and sturdier than other offerings on the market. The two sets of mounting holes on the camera end of the arm are to accommodate both the older and newer style mounting plates that come with the Unifi bullet cameras (G3 Bullets had a different hole spacing than the new G5 Bullets). The mounting arm is available in a short (125mm or about 6 inches) and long (225mm or nearly 9 inches) variation. The measurement refers to the distance from the corner of your mounting surface to the center of the camera base. The total length of the mounting arm is 68mm/2.68" longer than the base length. We include stainless steel screws for installation (#6 screws for mounting the arm and #8 screws for attaching the camera baseplate). The camera base plate will actually attach to the arm with the screws included with the camera, but we also include screws for that too just for good measure. If you are attaching to drywall or masonry then you will need to supply plastic wall anchors (readily and cheaply available at any hardware store). These are 3D printed parts which we make in-house (so you can expect some small aesthetic imperfections) and we can make them in white or black (please contact us for other colors). These are made with ASA plastic which has excellent outdoor characteristics such as UV and weather resistance. ASA is more expensive than other more commonly used 3D printing filaments but in this application we believe it is worth it. ASA also accepts paint nicely, which will be useful if you plan to paint these to match your house colors. We suggest using a primer before painting.